Ricoh 170 / 180 - Manual (Page 59)

Using the Redial Key
The machine remembers the last 10 (last one in a Type II Model) number that you
have input. If you have to redial the numbers, either:
❐ Type I Models: Just press the Redial key until the number or name of the party
you wish to redial is displayed, then press the Start key.
❐ Type II Models: Just press the Redial key, then press the Start key.
This feature has the following uses:
❐ If the machine is waiting to redial the other party, you do not have to wait for the
redialing interval to expire. Press the Redial key until the required telephone
number or name is displayed, then press the Start key.
❐ If you wish to send another message to the same address that you sent one to
recently, you don’t have to dial the full number again if it is still in the Redial
memory. Place the message in the feeder, then press the Start key.
❐ Press the Redial key until the required telephone number or name is
displayed, then press Start key.
NOTE: ❐ Using Redial, you cannot retry a failed Memory Transmission.
However, you can redial the telephone number, as explained in the
previous pages (Type I Only).
❐ Redial key employs the AI Short Protocol feature.
1. Follow both steps in any order.
❐ Press the Pause/Redial key until
the required number appears in the
display, then press the Yes key
twice. REDIAL Y/j k
n 08 ATLANTA OFFICE
❐ Carefully place your fax message
into the auto document feeder TRANSMIT OPTIONk
DIAL FAX NUMBER
2. Either:
❐ Select another number. (Type I Only: Broadcasting)
❐ Start the transmission : Press the Start key.
REDIALING
48