Ricoh 170 / 180 - Manual (Page 25)

Installation Procedure
1 Attach the accessories to the main machine.
1-1) Copy Tray [A]
1-2) Document Table [B]
1-3) Quick Dial Sheet [C]
1-4) Telephone Cord [D]
NOTE: Make sure the transparent
strip that prevents paper curling is
above the copy tray.
2. Install a thermal paper roll.
2-1) Lift the catch to unlock the
printer cover. Then, hold the
paper guides and open the
cover.
2-2) Unpack the thermal paper.
2-3) Set the paper guides [E] at each
end to match the paper size.
The paper roll must be set in
the center.
2-4) Install the rod into the paper roll
as shown, then set the roll into
the machine (hold the roll in a
direction so that it rolls away
from you when pulled upwards.)
NOTE: Make sure the ends of rod fit
into the paper guides there is no
slack paper inside the machine.
2-5) Pull out the leading edge and
insert it between the roller and
the cover until you can see the
leading edge of the paper.
NOTE:
❐ Make sure the transparent strip that
prevents paper curling is above the copy tray.
❐ Make sure the paper edges are aligned
with the marks printed by the roller.
[C]
[B]
[A]
[D]
[E]
8 1 /
A4
INSTALLING THE MACHINE
14