Ricoh 170 / 180 - Manual (Page 107)

6. Close the printer paper cover until it audi-
bly locks into place.
7. Tear off the excess paper: Press the Start
key.
COMMUNICATION PROBLEMS
If the Check Display indicator is lit and the message "
ERROR PRESS STOP
"
appears on the display, a communication has just failed. Press the Stop key to
return the machine to standby mode. If it was:
❐ An error during transmission: Resend the fax message. If the same problem
happens again, call the other party to make sure that their fax machine is
working.
❐ An error during reception: Call the sender and ask them to send the message
again.
OPERATING DIFFICULTIES
Symptom Required Action
The display is blank. If the power indicator is not lit, check that the
power cord is plugged in properly.
The machine cannot dial out
from behind a PBX. The number must contain the access code. A
pause may also be necessary after the access
code; if there is one already, try adding more
pauses.
The telephone keeps ringing
and no fax is printed. You are in Manual (TEL ) receive mode. Switch
to Auto or Fax mode.
The power cord is unplugged.
You cannot receive phone
calls; the unit only rings then
goes into fax receiving mode. You are in Fax mode. Switch to Auto or Tel
mode.
You cannot receive incoming
calls; the unit does not ring. Your machine’s telephone line cord is
disconnected.
Dialing is possible, but
Secured Polling is not. ID Codes do not match. Contact the other party
and agree on an ID Code.
The Check Display indicator
is lit There is a problem, check the error display and
correct the faults.
You hear an unusual noize
when closing operation
panel. The green levers are not pulled down correctly.
Pull down the levers to the bottom.
COMMUNICATION PROBLEMS
96