Ricoh 170 / 180 - Manual (Page 47)

Sending Quickly(Immediate Transmission)
For Type II models, you can skip step 1 and 2 because the machine is always in
Immediate Transmission mode. The advantages and disavantages of Immediate
Transmission and Memory Transmission are discussed on pages 35.
1. Make sure that the machine is in
standby mode.
READY 100% 10:00AM
SET DOC. OR DIAL NO.
2. If the display does not look like above,
then press the Line Select Key.
3. Follow both steps in any order
❐ You can dial in any of these ways: TRANSMIT Y/START
3104719266
a) Ten Keypad b) Quick Dial c) Speed Dial d) Handset
❐ Carefully place your fax message
face down into the document
feeder. TRANSMIT OPTIONk
DIAL FAX NUMBER
❐
The Pages must be placed in the feeder with the
first page at the bottom of the stack.
❐
Feed the pages in so that the top edge goes in first.
❐
Do not feed in more than 10 pages.
❐
Do not use unsuitable types of originals (see page
108).
❐
Adjust the document guides to fit the width of the
pages.
❐
Do not use pages of different sizes.
4. Press the Start key.
5. The machine dials and the line to the other party is connected. While it is
dialing, the number that you dialed is displayed (or if you used Quick Dial or
Speed Dial, the Quick Dial or Speed Dial Label stored for that number is
displayed). After transmission the machine will return to standby mode.
Selecting Resolution: See page 41.
Options for Sending a Message : See page 44.
Good Bad
SENDING IMMEDIATELY VS. SCANNING QUICKLY
36