Ricoh 170 / 180 - Manual (Page 135)

4. Use the
j
and the
k
keys to switch this
feature on or off.
NOTIFYING Y/ j k
kON OFF
5. Press the Yes key to store your setting,
then press the Function key.
When you go out, you can hear the received voice messages from your machine
using this feature. This feature will work only if the following conditions have been
met.
❐ When you use this feature from another place, You must be connected to a
telephone line that can accept DTMF (tone dial) signals.
❐ Your machine’s remote ID code must be programmed.
❐ Remote control must be switched on.
As a new machine has a Remote ID of 0000 when it leaves factory, we
recommend that you store a new Remote ID immediately.
1. Press the Function key and
6,2,2,2,2,6,1 using ten keypad, then
press the Yes key.
Y/NEXT k
SET PAGING TEL NO.
2. Press the
k
key until the screen is as
shown opposite.
Y/NEXT k
SET REMOTE ID
3. Press the Yes key. REMOTE CHANGE? Y/N
0000
4. Press the Yes key and the No key to
clear.
REMOTE ID KPAD
llll
5. Input the Remote ID that you wish to
use.
Example: 0826 , press 0,8,2,6 using the
ten keypad.
REMOTE ID Y/N
0826
6. Press the Yes key .
7. Finish: Press the Function key
1. Press the Function key and
6,2,2,2,2,6,2 using the ten keypad.
Then press the Yes key.
Y/NEXT k
SELECT LINE
2. Press the
k
key until " REMOTE
FUNC.ON/OFF " is displayed.
Y/NEXT k
REMOTE FUNC.ON/OFF