Ricoh 170 / 180 - Manual (Page 147)

Additional Information and Errata
[P51] Receiving with Auto Select mode
1. The machine start ringing.
2. You have two options:
❐ Pick up the handset. If a person is at the other end, you can continue a nor-
mal conversation. However, if it its a fax machine (if you hear the tone),
press the Start key, then replace the handset to receive the message.
❐ Do nothing. The machine keep ringing. After a number of rings (the auto
ring time ) the machine will begin to receive a message. You can change
the number of rings (the auto ring time) - see page 49.
[P15, 103, 103 and 105] Opening the printer cover
The printer cover catch is located in the center of the
cover. To release the printer cover, you need to
squeeze the catch Backwords -see opposite. the
cover will spring out slightly allowing you to raise it up.
NOTE: The catch must be squeezed backwards. If
you apply too much pressure in the opposite
direction the catch will become detached from
the machine. If this happens, follow the instruc-
tions below.
Reattaching the printer Cover Catch
If your printer cover catch becomes detached, it can be
easily be fixed. While holding printer cover open, push
the catch back into position in the direction shown
opposite. The catch should click into place.
[P106] Replacing the carriage
When you close the printer cover, but the "
REPLACE
PAPER
" or "
CLEAR COPY
" is still displayed, please
check the position of the carriage. It should be left side.
If it is not in that position, slide it back to the left.
Part No. H0688698