Ricoh 170 / 180 - Manual (Page 113)

A table showing the order of appearance of the switches is given below. Some of
these switches may not be seen depending on the options that have been
installed in the machine
(* this feature is available only on Type I models).
Feature Press
k
key
Telephone Line Type None
Authorized Reception Once
Daylight Saving Time (USA Only) twice
RDS 3 times
ECM * 4 times
Saving paper 5 times
Auto Cutter 6 times
Forwarding * 7 times
User Parameter Settings
A wide range of features can be switched on or off with the User Parameters.
However, this feature is more difficult to use than the On/ Off Switches. The
switches and adjustments are presented on the screen as rows of digits. Each
digit can be either 0 or 1. Each feature is allocated one or more digit. The value of
the digit determines the status of the feature.
The overall procedure is explained below. However, each of the adjustments that
can be made using this procedure are explained in the relevant parts of the
manual.
1. Press the Function key and
6,2,2,2,2,6,3 using the ten keypad, then
press the Yes key.
SETTING? Y/j
PRINT LIST j
❐
At this time, you can print a User parameter list.
Press the
j key, then press the Start key
2. Press the Yes key. The current settings
for switch 00 are now displayed on the
bottom line of the display. If the settings
for this switch are the way that you want
them, go to step 4.
KPAD/Y/j k
SWITCH 00:00000000
3. To change the required setting, press a
number from 0 to 7 using the ten keypad
corresponding to the digit that you wish
to change.
Example : Press 0. The value of digit 0
changes, in this case from 0 to 1.
KPAD/Y/j k
SWITCH 00:00000001
ON/ OFF SWITCHES AND USER PARAMETERS
102