Ricoh 170 / 180 - Manual (Page 33)

3. Press the Yes key. DAYLIGHT Y/j k
ON kOFF
4. Use the
j
and
k
keys to switch this fea-
ture on or off.
DAYLIGHT Y/j k
kON OFF
5. Press the Yes key to store your setting,
then press the Function key.
Cutting Paper
This machine has two paper cutting settings.
❐ Manual Paper Cutting
❐ Automatic Paper Cutting
You must select whether or not the machine should cut the paper automatically
after printing.
NOTE: When you are in manual paper cutting mode, after receiving or copying,
make sure that your machine is in standby mode and no document is in
the feeder, then press the Start key to cut the paper.
Switching the Automatic Cutter On
If you wish to use Automatic Cutting, you must switch the Automatic cutter on. Do
the following procedure.
1. Press the Function key and the
6,2,2,2,2,6,2 using the ten keypad, then
press the Yes key.
Y/NEXT k
SELECT LINE
2. Press the
k
key until the display is as
shown opposite.
Y/NEXTk
AUTO CUTTER ON/OFF
3. Press the Yes key. AUTO CUTTER Y/j k
kON OFF
4. Change the setting by using the
j
and
the
k
keys.
AUTO CUTTER Y/j k
ON kOFF
5. Press the Yes key to store your setting,
then press the Function key to finish.
SOME ITEMS MUST BE PROGRAMMED FIRST
22