Paradyne JetFusion Integrated Access Device - Manual (Page 79)

2000-A2-GB20-10 - 60 - February 2004
Configuring the Adaptive Rate Mode
1. Type 3 to display the SDSL Rate Mode menu.
Figure 4–15. Configure SDSL Rate Mode Menu
Type the option to select the rate mode.
If you set the rate mode to Nokia Auto-Cycle, you need to enter a line
rate value.
2. The IAD sets the rate mode and displays the menu.
3. Press Escape to return to the SDSL Configuration Menu.
Selecting the Line Rate
1. Type 4 to display the current line rate and a prompt:
Line Rate is currently: 88 Kbps
Enter xDSL Line Rate:
Type a line rate value (between 64 Kbps and 2320 Kbps), which must
be a value evenly divisible by 8.
2. The IAD sets the rate and displays the xDSL Configuration Menu.
3. Reset the IAD (page
14 ) when you finish WAN configuration.
Enabling and Disabling xDSL Debug Messages
Configur-
ing the
SDSL Inter-
face
The tasks described in this section all begin on the SDSL Configuration
menu. You should review and update each of these options as necessary,
and reset the IAD when you finish WAN configuration.
To configure the SDSL interface, Type 2 (Configure Physical Interface) on
the WAN Configuration menu to display the SDSL Configuration menu:
**************************************************
Configure SDSL Rate Mode
**************************************************
Current Rate Mode: AUTO-BAUD
1. Fixed
2. Auto-Baud
3. Lucent Sync Delay - Fixed
4. Lucent Sync Delay - Auto-Baud
5. Nokia Auto-Cycle
NOTE Option D, Enable/Disable G2237 xDSL Debug Messages, is
reserved for Paradyne network engineers.
LAN LINK LAN ACT WAN LINK VOICE POWER
JF2304
JF2308
JF2316 This section is for configuring the SDSL WAN interface on the
JF2304, JF2308 or JF2316.