Paradyne JetFusion Integrated Access Device - Manual (Page 106)

2000-A2-GB20-10 - 87 - February 2004
‹ Modifying an Existing DLCI ( Modifying a DLCI on page 87 )
‹ Deleting a DLCI ( Deleting a DLCI on page 90 )
‹ Showing Current DLCIs (page 90 )
You may configure up to 8 DLCIs on the IAD.
Modifying a DLCI
To modify a DLCI:
1. On the Frame Relay DLCI Configuration menu, type 2 to select Modify
Existing DLCI.
2. The IAD displays the port list and prompt:
Port DLCI Encapsulation
---- ----- -------------
1 16 RAW (No Encapsulation)
Select Port: [1-8]
Type the port number corresponding to the DLCI you want to update.
3. The IAD prompts you for the DLCI:
Enter dlci number [16]:
Type the DLCI number to change and press Enter.
4. The remainder of this task is identical to the steps in Adding a DLCI,
following. Proceed to step 3 in the next section and continue.
NOTE Before you configure DLCIs, you must first set the datalink
protocol to Frame Relay. If option 3 on the WAN
Configuration menu displays Configure PVCs instead of
Configure DLCIs, your datalink protocol is set to ATM instead
of Frame Relay.