Quick start guide, Chapter 2, 4xlfn 6wduw *xlgh – Paradyne JetFusion Integrated Access Device User Manual
Page 27
2000-A2-GB20-10
- 8 -
February 2004
This chapter describes the steps to install, connect, and set the IP address
of the JetFusion IAD. It introduces the menu interface and describes how
to perform basic configuration for common LAN and WAN environments. It
also describes basic operations—resetting the IAD, and logging off.
In many cases, all the information you need to get an IAD up and running
in a customer’s premises is contained in this single chapter.
This chapter contains the following topics:
Unpacking the IAD (page
Installing the IAD (page
)
Connecting via Terminal Emulator (page
Resetting the IAD (page
)
Powering up the IAD (page
Logging on to the IAD (page
Setting the Ethernet port IP address (page
)
Connecting via Telnet (page
)
Basic IAD configuration (page
)
Connecting the LAN, WAN, USI and Telephones (page
Confirming proper setup (page
)
In most installations, you’ll proceed through these topics in order. If your
situation varies, complete information on installation, connection,
configuration and troubleshooting is contained in the reference chapters
following this chapter.
4XLFN 6WDUW *XLGH
NOTE
When the IAD prompts you for input, the current value is
displayed in parentheses. To conveniently accept the current
value, just press Enter.