Paradyne JetFusion Integrated Access Device - Manual (Page 163)

2000-A2-GB20-10 - 144 - February 2004
2. The IAD saves the changes and displays the menu.
3. Press Escape to return to the CopperCom Configuration menu and
continue configuration.
4. Reset the IAD (page 14 ) when you finish voice path configuration.
CopperCom Debug Control
The commands in the CopperCom Debug Control menu are reserved for
use by Paradyne or CopperCom network engineers.
JetStream
Call Con-
trol Set-
tings
When you have specified the JetStream (Paradyne) Voice Gateway, type
E
to display the Call Control Settings menu for JetStream:
Figure 7–18. Call Control Menu for JetStream Voice Gateway
Type the option for the task to perform and proceed to the appropriate
section.
Displaying Statistics
Type A to display the JetStream Voice Gateway statistics report:
WAN RX PKTS
WAN RX BYTES
WAN TX PKTS
WAN TX BYTES
WAN TX DROPPED
POTS RX PKTS
POTS RX BYTES
POTS TX PKTS
POTS TX BYTES
POTS TX DROPPED
L2 RX PKTS
L2 RX BYTES
L2 TX PKTS
L2 TX BYTES
AAL2 HEC ERROR
Performing a Ring Test
Type R to set up and run a ring test.
The IAD displays the Ring Test menu:
*******************************************
Call Control Settings
*******************************************
A. Stats Display
R. Ring Test
S. Display IAD state
T. Trace
V. Pick sound heard if insufficient WAN B/W to
complete call
Z. Zero Stats Display
NOTE This command is reserved for use by Paradyne network
engineers only.