Paradyne JetFusion Integrated Access Device - Manual (Page 72)

2000-A2-GB20-10 - 53 - February 2004
Selecting
the Datalink
Protocol
If you are setting up voice and data channels, you can select ATM or
Frame Relay as you set up the channels, in the section Setting Up TDM
Voice, following.
To select ATM or Frame Relay as the datalink protocol:
1. On the WAN Configuration menu, type 1 to select Configure Datalink
Protocol.
2. The IAD displays the WAN Datalink Protocol Configuration menu,
identifying the current datalink protocol just below the banner.
Figure 4–4. WAN Datalink Protocol Configuration Menu
Selecting ATM or Frame Relay
When you select ATM as the datalink protocol, the IAD displays the ATM
and PVC options on the WAN Configuration menu:
Figure 4–5. WAN Configuration Menu (ATM)
When you select Frame Relay, the IAD displays the Frame Relay options
on the WAN Configuration menu:
NOTE You must sign on as Supervisor to configure the WAN
interface.
Be sure to reset the IAD when you are done making changes
to WAN settings. Resetting the IAD causes the configuration
changes to take effect.
*********************************************
WAN Datalink Protocol Configuration Menu
*********************************************
Current DataLink Protocol: Frame Relay
6. ATM
7. Frame Relay
LAN LINK LAN ACT WAN LINK VOICE POWER
JF2000
JF2100 JF2000 and JF2100 series IADs do not support Frame Relay.
*****************************************
WAN Configuration Menu
*****************************************
Configuring G2237 xDSL
1. Configure Datalink Protocol
2. Configure Physical Interface
3. Configure PVCs
4. Configure ATM Options Options 3 and 4
display ATM
configuration options