Paradyne JetFusion Integrated Access Device - Manual (Page 157)

2000-A2-GB20-10 - 138 - February 2004
When you select a specific country mode, the values are set automatically:
Figure 7–11. Country Mode Selection Menu
1. Type the letter corresponding to the country mode you want to set.
2. The IAD saves the mode you’ve selected and displays the menu.
3. Press Escape to return to the Voice Configuration menu and continue
with other voice path configuration.
4. Reset the IAD (page 14 ) when you finish voice path configuration.
Managing
MGCP
Embedded
Client
This section applies to MGCP—Voice Over IP—gateway management.
To configure or manage MGCP/NCS, type O to display the MGCP
Management menu:
LAN LINK LAN ACT WAN LINK VOICE POWER
JF2008
JF2104
JF2108 Ring frequency and impedance settings are automatically
applied to the JF2008, JF2104 and JF2108.
*******************************************
Country Mode Selection
*******************************************
Current Country Name is ETSI Generic
Current Country Mode is Europe
A. Australia Complex Impedance
B. ETSI Generic
C. United States of America
NOTE To add support for any of the countries/regions listed above
but not displayed in the Country Mode Selection menu,
contact your service provider to obtain the file.
NOTE The IAD only displays option O, Manage MGCP Embedded
Client on the Main menu if you selected Voice Over IP via
MGCP 0.1/NCS 1.0 or MGCP 1.0 as the Voice Gateway.