Paradyne JetFusion Integrated Access Device - Manual (Page 237)

2000-A2-GB20-10 - 218 - February 2004
You must enable bridging for this table to display. For more information on
enabling bridging, see
Bridge Configuration on page 118 .
Bridge Sta-
tus Report
To display information about bridging, type S on the Reports Menu. The
IAD displays a record for each interface:
The spanning state timer value is for listening or learning states and
counts down from the forward delay time to zero.
The hello timer value is valid only if the active port is the Root Bridge of the
network. It counts down from the hello time to zero.
‹ Root priority—priority of the root bridge on the network.
‹ ID—Ethernet MAC address of the root bridge on the network.
Press any key to return to the Reports menu.
PPP Autho-
rization
Entries
Report
Type P on the Reports menu to display information about PPP
authorization entries. If no PPP authorization entries have been created,
the IAD advises you by displaying this message:
No PPP Authorization Entries Configured.
Port Port for the Ethernet interface
Timer No. of seconds until this entry deletes from the
database. The time counts down from the
bridge database aging time value, in one-
second intervals; at zero, the entry deletes from
the database.
Table 12–28.Bridge Forwarding Database Report
Parameter Description
Table 12–29.Bridge Status Report
Parameter Description
Interface interface for the active slot for bridging
Port port for the preceding interface
Spanning Tree Protocol (STP) enabled | disabled
State Spanning tree state: disabled | blocking |
listening |learning | forwarding
Root root port for the bridge—yes | no
Designated designated port for the bridge—yes | no
Timers current values of the spanning state timer (first
value) and the hello timer (second value)