Paradyne JetFusion Integrated Access Device - Manual (Page 121)

2000-A2-GB20-10 - 102 - February 2004
1. Type P on the Router Configuration menu to select Configure RIP
Poisoned Reverse by Port.
2. The IAD displays the interfaces on this IAD (sample shown):
Available Interfaces:
1. SDSL
2. 10/100BaseT Ethernet
0. (Abort)
Type the number of the port to enable or disable.
3. The IAD displays the RIP status of this port and a prompt:
RIP Poisoned Reverse for Slot 1, Port 1 is currently
DISABLED
Enter E to Enable, D to Disable:
Type E to enable RIP Poisoned Reverse, or type D to disable it.
4. The IAD saves the configuration, and displays the Router
Configuration menu.
5. Repeat these steps for each port for which you want to enable RIP
poisoned reverse.
6. Continue with other configuration tasks, or press Escape to return to
the Main menu.
7. Reset the IAD (page 14 ) when you finish router configuration.
Setting the RIP Version
To set the RIP version:
1. Type V on the Router Configuration menu to select Configure RIP
Version by Port.
2. If more than one WAN port is installed or more than one PVC/DLCI
exists, the IAD displays the interfaces on this IAD (sample shown):
Available Interfaces:
1. SDSL
2. 10/100BaseT Ethernet
0. (Abort)
Type the interface number to set.
3. The IAD displays the port table for this interface and prompts for a port:
Port VPI VCI Encapsulation Type PCR Service
1 0 40 RFC 1483 (with LLC Encap)3641 UBR
Total = 3641 cps
Maximum PCR this interface can support = 3622 cps
Select Port: [1-8]
Type the port to set and press Enter.
4. The IAD displays the RIP configuration and status of the slot and port
you’re setting, and prompts for a new version:
Current RIP configuration for Slot 1, Port 1 is
Disabled
Enter RIP Version for Port 1
0. Disabled
1. Version 1 Broadcast
2. Version 2 Broadcast
3. Version 2 Multicast
Type the option number of the version to set.