Paradyne JetFusion Integrated Access Device User Manual

Page 160

2000-A2-GB20-10

- 141 -

February 2004

Setting Admin State Globally

1. Type 1 to enable or disable the admin state for all ports.
2. The IAD displays this prompt:

Enter E to Enable, D to Disable:

Type E to enable the admin state, or D to disable it.

3. The IAD saves the mode you’ve selected and displays the menu.
4. Press Escape to return to the Port Administration menu and continue

with other voice path configuration.

) when you finish voice path configuration.

Displaying the Current Admin State

Type 2 to display the current admin state by port number.

The IAD displays the following report:

DISABLED

ENABLED

DISABLED

Press any key to return to the Port Administration menu.

Configuring Admin State per port

1. Type 3 to enable or disable the admin state for a specific port. The IAD

displays the port prompt:
Select Line: [1-8]

Type the port number to set.

2. The IAD displays the following prompt:

Enter E to Enable, D to Disable:

Type E to enable the admin state, or D to disable it.

3. The IAD saves the mode you’ve selected and displays the menu.
4. Press Escape to return to the Port Administration menu and continue

with other voice path configuration.

) when you finish voice path configuration.

Restarting an Endpoint

Type 4 to reset the connection between the Voice Port phone and the
MGCP voice gateway.

You use this option if one side of the link incorrectly identifies a call as up
and the other side thinks the call as down.

To reset the connection, type the number of the port and press Enter.

Configuring Default Packet Size

1. Type P to configure the packet size (default 5.5 ms).
2. The IAD displays the following prompt:

Enter packet size in ms [5.5]>

Type the packet size value and press Enter.

3. The IAD saves the new packet size and displays the menu.
4. Press Escape to return to the MGCP menu and continue with other

voice path configuration.

) when you finish voice path configuration.