Voice path configuration, Basic voice path setup tasks, Chapter 7 – Paradyne JetFusion Integrated Access Device User Manual
Page 146: 9rlfh 3dwk &rqiljxudwlrq
2000-A2-GB20-10
- 127 -
February 2004
After you have defined the voice PVCs or DLCIs on the IAD, you should
configure the voice path for voice operation to function correctly.
This chapter contains the following topics:
Basic Voice Path Setup Tasks (page
Voice Path Configuration Menu (page
Setting the Voice Gateway (page
)
Setting Jitter Delay (page
Setting Start Mode (page
Setting SLIC Control Mode (page
Setting Compander Mode (page
)
Setting On Hook Transmission Mode (page
Setting Idle Voltage Mode (page
Setting Debug Mode (page
Configuring Echo Cancellation (page
)
Setting Loop Gain (page
)
Setting Country Mode (page
)
Basic Voice
Path Setup
Tasks
To configure voice path settings, you should complete the following tasks:
Select a voice gateway (page
Set the jitter delay (page
)
Set start mode (page
Set Compander mode (page
Set echo cancellation (page
)
Set loop gain (page
Set bandwidth tone (page
)
9RLFH 3DWK
&RQILJXUDWLRQ
NOTE
When the IAD prompts you for input, the current value is
displayed in parentheses. To conveniently accept the current
value, just press Enter.