Paradyne JetFusion Integrated Access Device - Manual (Page 110)

2000-A2-GB20-10 - 91 - February 2004
‹ Configuring Maintenance Protocol (page 93 )
‹ Configuring Congestion Parameters (page 93 )
‹ Enabling or Disabling Coppermountain CMCP (page 94 )
Selecting Fragmentation Types
To select which fragmentation to use:
1. On the Frame Relay Options menu, type 1 to display the FR
Fragmentation Configuration menu.
Figure 4–61. Frame Relay Fragmentation Configuration Menu
2. Do one of the following:
a. Type 1 to select Configure FRF.12 Fragmentation—go to FRF.12
Configuration, following.
—or—
b. Type 2 to select CopperMountain Fragmentation—go to
CopperMountain Fragmentation Configuration, on page
92 .
Setting FRF.12 Configuration
If you selected FRF.12 Fragmentation, the IAD displays the FRF.12
Configuration menu:
Figure 4–62. FRF.12 Configuration Menu
Type the option and proceed to the corresponding section.
Enabling or Disabling FRF.12
1. Type 1 to enable or disable FRF.12.
The IAD displays the status and a prompt:
FRF.12 Fragmentation is currently DISABLED
Enter E to Enable, D to Disable:
Type E to enable End-to-End fragmentation, or type D to disable it.
2. The IAD saves the configuration and displays the FR FRF.12
Configuration menu. Press Escape to continue.
3. Reset the IAD (page 14 ) when you finish Frame Relay configuration.
*****************************************
FR Fragmentation Configuration
*****************************************
1. Configure FRF.12 Fragmentation
2. Configure CopperMountain Fragmentation
*****************************************
FR FRF.12 Configuration
*****************************************
1. Enable/Disable FRF.12
2. Enable Automatic Fragment Sizing
3. Set Manual Fragment Size