FUJITSU Primergy RX200 S2 - Manual (Page 62)

62
Chapter 3 OS Installation Using ServerStart
If you are in guided mode and want to start up the disk wizard again after exiting the wizard, save the
configuration file.
ServerStart may restart when the disk wizard restarts. If this occurs, open the configuration file you
have saved and start setting from the item where you have discontinued. If the configuration file is not
saved, the settings are lost. Start setting again from the beginning.
3.1.5 OS Installation Wizard
Set computer information, user information, and the network protocol.
ServerStart can configure multiple network patterns. When configuring a domain controller, refer to
"Using ServerStart to configure the Network".
The setup window differs depending on the OS to be installed. The following describes operations on
Windows Server 2003.
1
Click [Operating System Wizard: Operating system parameters].
The [Windows Installation] window appears.
2
Enter the password in [Password for Administrator account] and click [Next].
If the password differs between [Password for Administrator account] and [Please repeat Pass-
word], an error dialog window appears. Enter the correct password.