beautypg.com

3 software troubleshooting, 3 software troubleshooting" (pg.260), Trouble at a serverstart startup – FUJITSU Primergy RX200 S2 User Manual

Page 260: Trouble during os installation

background image

260

Chapter 9 Operation and Maintenance

9.2.3 Software Troubleshooting

This section explains software related troubleshooting. For troubles during OS installation or system

operation, refer to the following contents.

■ Trouble at a ServerStart Startup

After a boot from the ServerStart CD-ROM, nothing is displayed on the
screen.

This problem may occur if the hard disk drive still contains previous information. In that case, this

problem will occur when the Windows Server 2003 Installation CD-ROM is inserted.

To eliminate this problem, physically format the hard disk drive to delete the previous information and

start up ServerStart. For physical formatting, refer to "8.3.8 Formatting hard disks physically"

( pg.244).

■ Trouble during OS Installation

Automatic logon is not performed during Windows 2000 setup.

During OS installation, ServerStart installs applications and hardware utilities supplied with the OS.

Installation and subsequent restart and logon are performed automatically as necessary. In rare cases,

however, automatic logon is not performed and the logon window appears. In this widow, use the user

name and password you have set before starting installation. After logon, the setup procedures are

continued.

Automatic installation stopped at an entry screen during Active Directory
configuration.

If automatic installation has stopped during Active Directory configuration, check the error message

first. Automatic installation can stop when the password is required, such as when registration in DNS

fails. Check the environment and continue the installation manually. If the problem is not solved, click

[Cancel] and after the OS installation, manually configure Active Directory.

If you have continued the Active Directory installation wizard manually, the following message appears

when the installation wizard closes.

When this message appears, click [Restart] to continue the installation.

"You must restart Windows to make the settings in the Active Directory

installation wizard effective."