FUJITSU Primergy RX200 S2 - Manual (Page 168)

168
Chapter 7 Installing Internal Options
9
Loosen the screw on the rear of the server.
10
Slide the top cover slowly to the rear and lift it to remove from the server.
■ How to Attach the Top Cover
To attach the top cover, simply reverse procedures in "7.2.1 How to Remove the Top Cover" ( pg.166).
Notes on installing the server on the rack
Pull part A on the slide rail (on both sides) toward the front of the slide rail until it stops.
When sliding the server backward, be sure to keep the slide rails and inner rails on both sides parallel
to each other.
Check to make sure no tools or unnecessary components were left inside the server before attaching
the top cover back into place.
When sliding the server backward, press the locks on both sides of the rails to unlock.
Before turning on the server, make sure that the top cover is attached.
Top cover
Part A
Lock
Slide rail
Inner rail