FUJITSU Primergy RX200 S2 - Manual (Page 54)

54
Chapter 3 OS Installation Using ServerStart
3.1 Guided Mode
In guided mode, follow the wizard to specify hardware configuration and the OS to be
installed, save the information necessary for installation in a configuration file, and
install the OS.
3.1.1 Starting Up the Guided Mode
Start up the guided mode.
When you do not configure an array but will perform installation to an array-configured server, remove
the array before starting up ServerStart.For the procedure for deleting an array, refer to "8.3.7 RAID
Properties Submenu" ( pg.242).
1
Turn on the server and insert the ServerStart CD-ROM immediately.
ServerStart starts up and a message appears prompting you to insert the ServerStart floppy disk.
2
Insert the ServerStart floppy disk supplied with the server. Make sure that
"Removable media" and "A:" are selected and click [Create].
Set the ServerStart floppy disk in the write-enabled state.