FUJITSU Primergy RX200 S2 - Manual (Page 273)

273
PRIMERGY RX200 S2 User’s Guide
9
O
p
eration
a
nd
Mainten
ance
When only the user or administrator password is set, the same setting items are accessible to both
users and administrators.
When both passwords are set, users can set dates and user passwords only.
■ Changing/Deleting a Password
1
Enter the current password in the [Enter Current Password] field in the
password entry window.
2
Enter a new password in the [Enter New Password] field.
To delete the password, enter nothing and perform Step 4.
3
In the [Confirm New Password] field, enter the password you have entered in
Step 2.
To delete the password, enter nothing and perform Step 4.
4
Press the [Enter] key.
When you delete the password, [System Password] or [Setup Password] on the [Security] menu
shows [Not installed].
The system shuts down after three invalid password entries. If this happens, power off the server, turn
it back on, and then enter the correct password.
If you forget your password and cannot start the server, change the jumper pin setting on the
baseboard to clear the CMOS storing the password. Change the jumper pin setting back, and return
the BIOS Setup Utility to the original setting. Then, set the password using this utility.
"8.1 Jumper Pin Settings" (pg.206)
Set Setup(System) Password
Enter Current Password [ ]
Confirm New Password [ ]
Enter New Password [ ]