FUJITSU Primergy RX200 S2 - Manual (Page 199)

199
PRIMERGY RX200 S2 User’s Guide
Inst
allin
g I
nte
rn
al O
pti
ons
7
7.8.4 Replacing a Power Supply Unit when the Redundant
Function is Enabled
When the system power supply redundant function is enabled, a failed power supply unit can be
replaced without turning off the server.
After removing the power supply unit, be sure to install a new unit.
■ Power Supply Unit LED Status
■ Replacing the Power Supply Unit
1
Remove the power cable from the failed power supply unit.
2
Remove the failed power supply unit.
"
■
How to Remove the Power Supply Unit" ( pg.198)
3
Install the new power supply unit.
4
Plug the power cable into the inlet of the new power supply unit.
Power supply unit LED
Green On: The unit is operating normally
Amber On: An AC power supply is connected
or an error is detected in the
power supply unit