FUJITSU Primergy RX200 S2 - Manual (Page 244)

244
Chapter 8 Hardware Configuration/Utilities
2
Select [Delete Array] and press the [Enter] key.
3
When [RAID Properties Changed] appears, select [Save changes then exit this
menu] and press the [Enter] key.
8.3.8 Formatting hard disks physically
On this server, physical formatting cannot be performed from SCSI Setup Utility menus.
When a hard disk must be formatted physically, perform the following procedure to run the SCSI Low-
Level Format Utility.
Physical formatting deletes all data on the selected hard disk. Make a backup before using this
function.
Physical formatting of a hard disk takes time. Once started, it cannot be aborted. Perform it when you
have enough time.
Do not turn off or reset the server during physical formatting. Otherwise, the hard disk may be
damaged.
The "Server Management Tools" disk supplied with the server is required.
Hard disk units in a disk array configuration cannot be physically formatted. Delete the disk array
beforehand. For the procedure for deleting a disk array, refer to "
■
Deleting a Disk Array" ( pg.243).
■ Performing Physical Formatting
1
Insert the "Server Management Tools" disk and turn the server on.
2
When a command prompt is displayed, enter the following command and press
the [Enter] key.
A:\SMTOOL\>ASPIFMT.EXE
The SCSI Low-Level Format Utility starts up.
LSI Logic MPT SCSI Setup Utility Version MPTBIOS-IMx.xx.xx
Esc=Abort/Exit ArrowKeys=Select Item -/+=Change[Item]
Home/End=Select Item Enter=Execute
SCSI
ID
0
1 Array
DISK?
[Yes]
[Yes]
RAID Properties Array: SCSI ID: Size(MB):
Hot
Spare
[No]
[No] Status Predict
Failure Size
(MB) Device Identifier
- ***MB Primary
Out of Sync
***MB