FUJITSU Primergy RX200 S2 - Manual (Page 154)

154
Chapter 5 Operations after OS Installation
• The controllers of the onboard LAN and LAN cards are as follows.
5.6.2 Cautions for PG-1852/1862/188x/189xLAN Driver V8.3
■ Event Log
Once a Team is setup, multiple identical logs from the same source that starts with the following log may
be stored in the system log file of the event viewer at system start-up.
Since such event logs will be stored nonetheless even if the Teaming function is operated normally,
ignore them.
5.6.3 Teaming Function
■ Notes
When using the Teaming function, note the following points.
• You require Service Pack 2 or later for Windows 2000 Server.
• For AFT/ALB/FEC/GEC type, you can incorporate up to four LAN ports into one team and two ports
for a SFT type team.
• Once a Team is created, virtual adapters (Intel
®
Advanced Network Service Virtual Adapter) will be
created in the [Device Manager] and/or [Network and Dial-up Connections] of the system. Do not
disable or delete this virtual adapter from the [Device Manager] or [Network and Dial-up
Connections]. When deleting a virtual adapter, make sure to use "Intel
®
PROSet".
• When the Teaming function is being used, you can only use the following protocols.
• For AFT/SFT/FEC/GEC type: IP, NetBEUI, IPX (NCP), IPX (NetBIOS)
• For ALB type: IP, IPX (NCP)
• When the Teaming function is being used, you cannot use the hardware assist function of IPSEC. Do
not use this function even if the function is installed in all cards in the team.
table: Controller being used
LAN cards Controller being used
Onboard LAN (1000BASE-T) Intel
®
82547GB
PG-1852 Intel
®
82540EM
PG-1862 Intel
®
82546EB
PG-1882L/PG-1892L
Intel
®
82545GM
Source iANSMiniport
ID 11
Type Warning
Description The following adaptor link is not connected: (Adapter name)
* (Adapter name) varies depending on the OS or hardware configuration.