FUJITSU Primergy RX200 S2 User Manual
Page 265
265
PRIMERGY RX200 S2 User’s Guide
9
O
p
eration
a
nd
Mainten
ance
■ Fails in Remote Installation
If remote installation fails, check the following.
●
Checking Services
Check that the DHCP, PXE Service, and TFTP Service are running.
For checking procedures, refer to "3.4 Remote Installation" ( pg.85).
●
Setting TFTP
To access TFTP Service, add a Guest account to the TFTP folder and set the full control rights.
For setting procedures, refer to "3.4 Remote Installation" ( pg.85).
●
Checking Network Function Settings
The server must support the network function (PXE).
For the setting procedure, refer to "Performing Remote Installation" in "2.1.2 Hardware Settings"
●
Checking the MAC Address
Check that the current MAC address is the correct MAC address of the server.
For the MAC address checking procedure, refer to "Performing Remote Installation" in "2.1.2 Hardware
●
Checking LAN Cable Connection
Check that the LAN cable is connected to the LAN card corresponding to the specified MAC address
and that the LAN card is connected to the network.
■ SNMP Service Startup Fails
Regardless of whether the Simple Network Management Protocol (SNMP) is installed, if the SNMP
service is not started, perform the following procedure to start the SNMP service.
●
For Windows Server 2003
1
Click [Start]
→ [Administrative Tools] → [Computer Management].
2
Select [Services] from [Services and Applications].
3
From the details, select [SNMP Service].
4
Select [Start] from the [Action] menu.