FUJITSU INTEGRATED REMOTE MANAGEMENT CONTROLLER IRMC S2/S3 User Manual
Remote management
Table of contents
Document Outline
- Contents
- Preface
- Purpose and target groups of the manual
- Functions of the iRMC S2/S3 (overview)
- Communication interfaces of the iRMC S2/S3
- Communication protocols used by the iRMC S2/S3
- IPMI - technical background
- DCMI (Data Center Management Interface)
- Changes since the previous versions of the manual
- ServerView Suite link collection
- Documentation for ServerView Suite
- Notational conventions
- Logging on to the iRMC S2/S3 for the first time
- Configuring the iRMC S2/S3
- Configuring the LAN interface of the iRMC S2/S3
- Configuring text console redirection via LAN using the BIOS / TrustedCore / UEFI setup utility
- Configuring and using the serial interface of the iRMC S2/S3
- Configuring the iRMC S2/S3 over the iRMC S2/S3 web interface
- User management for the iRMC S2/S3
- Advanced Video Redirection (AVR)
- Remote Storage
- iRMC S2/S3 web interface
- Logging into the iRMC S2/S3 web interface
- Required user permissions
- Structure of the user interface
- System Information - Information on the server
- BIOS - Backing up/restore BIOS settings, flashing BIOS
- iRMC S2/S3 - Information, firmware and certificates
- Power Management
- Power Consumption
- Sensors - Check status of the sensors
- System Event Log and Internal Event Log
- Server Management Information - Configuring the server settings
- Network Settings - Configure the LAN parameters
- Alerting - Configure alerting
- User Management
- Console Redirection - Redirecting the console
- Remote Storage
- Operating iRMC S2/S3 via Telnet / SSH (Remote Manager)
- iRMC S2/S3 via Telnet/SSH (Remote Manager)
- Requirements on the managed server
- Operating Remote Manager
- Overview of menus
- Logging in
- Main menu of the Remote Manager
- Required user permissions
- Change the password
- System Information - Information on the managed server
- Power Management
- Enclosure Information - System event log and status of the sensors
- Service processor - IP parameters, identification LED and iRMC S2/S3 reset
- Console Redirection (EMS/SAC) - Start text console redirection
- Start a Command Line shell... - Start a SMASH CLP shell
- Console Logging - Redirect message output to the text console (serial)
- Command Line Protocol (CLP)
- Configuring iRMC S2/S3 using the Server Configuration Manager
- Firmware update
- Remote installation of the operating system via iRMC S2/S3
- Appendix