FUJITSU INTEGRATED REMOTE MANAGEMENT CONTROLLER IRMC S2/S3 User Manual
Page 236
236
iRMC
S2/S3
Server Management Information - Configuring the server settings
Proceed as follows:
Ê
Check or uncheck the option(s) under
Enabled
for the
Software Watchdog
and/or
Boot Watchdog
.
Ê
If you have activated either of these options, you can configure the following
settings after
Software Watchdog
and/or
Boot Watchdog
:
Continue
No action is performed when the watchdog has expired, i.e. the
server continues to run. An entry is made in the event log.
Reset
The server management software triggers a system reset.
Power Cycle
The server is powered down and immediately powered up again.
Ê
As appropriate, enter the time (in minutes) after which this action is to be
performed following
after timeout delay
.
I
The boot watchdog must wait until the system has been started. You
therefore have to specify a sufficient period for
after timeout delay (1 -
100)
.
Ê
Click
Apply
button.
The configured settings are saved and the actions which have been
configured are performed in the appropriate circumstances.