FUJITSU INTEGRATED REMOTE MANAGEMENT CONTROLLER IRMC S2/S3 - Manual (Page 62)

62 iRMC S2/S3
Configuring and using the serial interface of the iRMC S2/S3
Flow Control
None
Exiting the UEFI setup utility
Ê Save your settings and exit the UEFI setup utility.
Ê Continue with section "Testing the LAN interface" on page 47 .
3.3.3 Using the Remote Manager (Serial) interface
If you connect a computer over a null modem cable and start a terminal program
(VT100+) on this computer, you can access the Remote Manager (Serial)
terminal program. The Remote Manager (Serial) interface is identical to the
Remote Manager interface (see
chapter "iRMC S2/S3 via Telnet/SSH (Remote
Manager)" on page 321 ).
Prerequisites
On the managed server:
The Serial Multiplexer BIOS setting must be configured on the iRMC (see
section "Configuring the serial interface of the iRMC S2" on page 58 ).
Terminal program (VT100+):
Configure the following port settings for the terminal program:
Bits per second
Set the value to 9600 .
Data bits
Set the value to 8 .
Parity
Set the value to None .
Stop bits
Set the value to 1 .
Flow Control
Set the value to None .