Configuring the serial interface of the irmc s2, 1 configuring the serial interface of the irmc s2 – FUJITSU INTEGRATED REMOTE MANAGEMENT CONTROLLER IRMC S2/S3 User Manual
Page 58

58
iRMC
S2/S3
Configuring and using the serial interface of the iRMC S2/S3
3.3.1
Configuring the serial interface of the iRMC S2
Ê
Call the BIOS / TrustedCore setup utility of the managed server. Do this by
pressing
[F2]
while the server is booting.
Ê
Call the
Peripheral Configuration
menu to configure the serial port:
Advanced – Peripheral Configuration
Figure 16: Peripheral Configuration menu (as it appears in the TrustedCore setup utility)
Ê
Configure the following settings:
Serial 1
Set the value to
Enabled
.
Serial 1 Address
Accept the first value pair proposed.
Serial Multiplexer
Set the value to
iRMC
.