FUJITSU INTEGRATED REMOTE MANAGEMENT CONTROLLER IRMC S2/S3 User Manual
Page 83
iRMC S2/S3
83
Local user management for the iRMC S2/S3
I
Although this file contains no security-critical information, read/write
permission should only be granted to the owner. Access should be
denied to all other users.
3. System-wide configuration file (
/etc/ssh/ssh_config
)
This file contains default values for configuration parameters
–
if there is no user-specific configuration file or
–
if the relevant parameters are not specified in the user-specific
configuration file.
The value found first applies for each option.
I
You will find detailed information on the configuration of
ssh
and on its
operands on the manual pages for OpenSSH under
http://www.openssh.org/manual.html
Proceed as follows:
Ê
Start
ssh
, to log in to the iRMC S2/S3 under SSHv2-authentication:
ssh -l [
or
ssh [
User name under which you want to log into the iRMC S2/S3. If you
do not specify
ssh
uses the user name under which you are
logged into your local computer to log you in to iRMC S2/S3.
iRMC S2/S3 name or IP address of the iRMC S2/S3 you want to log
into.
Example: SSHv2-authenticated login on the iRMC S2/S3
For the following
ssh
- call, it is assumed that
ssh-keygen
has been used to
generate a public/private RSA key pair as described under
Generating an RSA key pair with ssh -keygen" on page 75
public key
User1/.ssh/id_rsa.pub
has been loaded onto the iRMC S2/S3 for an
iRMC S2/S3 user
user4
(see
You can then log in from your local computer under
$HOME/User1
as follows
on the iRMC S2 "RX100_S52-iRMC" using the login
user4
: