FUJITSU INTEGRATED REMOTE MANAGEMENT CONTROLLER IRMC S2/S3 - Manual (Page 30)

30 iRMC S2/S3
Changes compared with the previous version
1.7 Changes since the previous versions of the
manual
iRMC S2/S3 - integrated Remote Management Controller
(edition Ju
ly
2012)
This manual refers to the iRMC S2/S3 firmware version 6.5x and replaces the
following online manual: “iRMC S2/S3 - integrated Remote Management
Controller”, May 2012 edition.
The manual includes the following updates:
● The "0 Watt Technology" feature is described in Chapter "7 iRMC S2/S3 web
interface".
● The former chapter "12 IPMI OEM Commands" has been expanded and is
now an Appendix ("12 Appendix") to the manual, containing the following
sections:
– "12.1 IPMI OEM Commands supported by the iRMC S2/S3" (former
chapter "12 IPMI OEM Commands")
– "12.2 Configuring the iRMC S2/S3 via SCCI and scripted configuration"
(new section).
iRMC S2/S3 - integrated Remote Management Controller
(edition May 2012)
This manual refers to the iRMC S2/S3 firmware version 6.5x and replaces the
following online manual: “iRMC S2 - integrated Remote Management
Controller”, November 2011 edition.
New iRMC S2/S3 features (described in Chapter "7 iRMC S2/S3 web
interface"):
● Agentless HDD monitoring (iRMC S3 only)
If the managed server supports the "agentless HDD monitoring" feature, the
HDD status of each individual HDD is directly read and reported to the
iRMC S2/S3 via a dedicated lightpath status sensor and thus can be
displayed even in the case no ServerView agents are running.
● Backing up/restoring BIOS settings, flashing BIOS
If the BIOS of the managed server meets the corresponding feature
requirements, the iRMC S2/S3 allows you to perform the following actions: