FUJITSU INTEGRATED REMOTE MANAGEMENT CONTROLLER IRMC S2/S3 - Manual (Page 321)

iRMC S2/S3 321
8 iRMC S2/S3 via Telnet/SSH
(Remote Manager)
A Telnet-based interface is available for the iRMC S2/S3. This is known as the
Remote Manager. You can call the Remote Manager over the following
interfaces:
– iRMC S2/S3 web interface (see page 315 )
– any Telnet/SSH client
The iRMC S2/S3 supports secure connections over SSH (Secure Shell). The
Remote Manager interface is identical for Telnet and SSH connections. In
principle, any Telnet/SSH client that interprets VT100 sequences can be used
to access the iRMC S2/S3. It is nevertheless recommended that the
iRMC S2/S3 web interface or the ServerView Remote Management Frontend
(referred to below simply as the Remote Management Frontend) be used.
I
Maximum number of parallel sessions:
– Telnet: up to 4
– SSH: up to 4
– Telnet and SSH in total: up to 4
This chapter describes operation of the iRMC S2/S3 from the Remote Manager
and the various functions in detail. The end of the chapter also provides a brief
overview of SMASH CLP.