Magewell USB Fusion HDMI & USB Video Capture Device - Manual (Page 91)

The output video will be mirrored immediately.
Setting the App Login Password
When the App connects to a USB Fusion device, no password is required by
default. You can set a password to enhance security.
1. In the navigation bar at the upper part of the Web UI, click General .
2. Click APP at the upper part.
3. In the Login area, check Verify password after Secure login to enable
password authentication.
4. In the Set Password dialog box, enter a password, and click OK .
The password is case sensitive, ranging from 1 to 32 characters. Supported
characters are as follows: A-Z, a-z, 0-9, and special characters
_~!@#$%^&*-+=
After setting the password:
Setting the Encoding Format
The encoding format is used by the USB Fusion device to deliver video streams
to the App. You can set these parameters based on your network conditions. A
higher resolution/frame rate/bit rate will require more bandwidth.
1. In the navigation bar at the upper part of the Web UI, click General .
If you forget the password, click Change password to make the change. ■
If you need to disable password verification, uncheck Verify password .
When you enable password verification again, you will not be prompted to
enter a new password. The password you set last time is still valid.
■
91