Magewell USB Fusion HDMI & USB Video Capture Device - Manual (Page 139)

6. To change the AP password, click Change Password , enter and confirm
the new AP password, and click OK .
7. To switch back to the Wi-Fi mode, click Enable Wi-Fi .
selected country and mode. A channel with less interference will
provide better communication quality.
IP address : The default is 192.168.67.1. Only the third segment can be
modified, ranging from 0 to 254. Ensure the IP address is unique on
the local network.
The system automatically checks whether this IP address is the same as
the USB network IP address. If yes, you will be prompted with an error.
■
DHCP IP start : Start IP address assigned by the AP to connected
devices. Only the fourth segment can be modified, which ranges from
2 to a value less than DHCP IP end
■
DHCP IP end : End IP address assigned by the AP to connected
devices. Only the fourth segment can be modified, which ranges from
a value greater than DHCP IP start to 254.
■
Share Ethernet : Whether the Ethernet connection can be shared after
the AP is enabled. By default, this function is enabled, allowing devices
connected to the AP to use the Ethernet connection of USB Fusion.
■
After you change IP address and click Apply , if you are
currently accessing the web UI using the IP address of the AP,
since the original IP address can no longer be used for access,
the device will log you out.
139