Magewell USB Fusion HDMI & USB Video Capture Device - Manual (Page 134)

Using a Static IP Address
USB Fusion uses an DHCP-assigned IP address by default, which can effectively
avoid IP address conflict, but can also result in constant IP address changes.
if no DHCP service is available in a network, you can manually set a static IP
address for USB Fusion. The static IP address will remain unchanged. However,
you must make sure that this IP address is not used by any other device on the
same network.
1. Log in to the web UI as the Admin user.
2. Choose System > Network .
3. In the Ethernet area, click Edit .
4. On the displayed window, enable Set IP Address Manually , and set IP
Address , Submask , and Gateway .
The current network settings are used by default. Only IPv4 addresses are
supported, while IPv6 address are not.
5. Click Apply .
6. In the address bar of a browser, enter the new IP address to ensure it can
be used to access USB Fusion.
To change back to using the DHCP service to obtain an IP address,
disable Use Static IP Address and click Apply . The parameters in
the dialog box will be restored to their defaults.
If you are currently accessing the web UI using an Ethernet IP
address, since the original IP address can no longer be used for
access, the device will log you out.
134