Baseline Systems BaseStation 3200 V12 - Manual (Page 99)

BaseStation 3200 Advanced Irrigation Controller Manual
Next to the time and date, you see the status or state of the following items.
• BaseMgr – Indicates the status of the controller’s connection to BaseManager.
• Two-wire – Indicates the approximate current being supplied to the two-wire path. The value
will vary with the size of the installation and the number of active valves. When the system is
not watering, the two-wire status is OFF unless the two-wire is to be always on.
• Flow – If there is no flow meter installed, the controller shows the estimated flow (in
brackets) based on the flow values that have been set for each zone. With one or more flow
meters, the controller indicates the total flow measured. This value is updated once each
minute, and is shown without brackets. More detail is available on the Water Used report.
• Pump/MV Status – Shows the status of each master valve.
• Prog – Shows the status of all programs. Refer to the status color key on the label inside the
door of the controller.
• Zone Status – The lower section shows the current status of the zones in groups of 50 zones.
Press the + or – button to move between the groups 50 zones.
Status Colors
The following colors display on the RUN screen to indicate the status of programs, master valves,
flow meters, and zones.
Idle (watering done)
Active (watering)
Waiting to water
Soaking
Disabled
Paused
Off or Message (blinking)
Unused
Page 93