Baseline Systems BaseStation 3200 V12 - Manual (Page 67)

BaseStation 3200 Advanced Irrigation Controller Manual
9. Press the Next button to move to the Enable column of the Stop field. Press the + button to
toggle the setting between Off, Below, Above, and Equals.
10. Press the Next button to move to the Value column of the Stop field. Press the + button to
change the value in the field.
11. Press the Next button to move to the Enable column of the Pause field. Press the + button to
toggle the setting between Off, Below, Above, and Equals.
12. Press the Next button to move to the Value column of the Pause field. Press the + button to
change the value in the field.
13. Press the Next button to move to the Pause Time field. Press the + or – button to change the
value in the field.
14. When you have finished making changes, turn the dial to the RUN position.
When the soil moisture sensor detects a start, stop, or pause condition, it causes the
controller to respond according to the settings and displays a message on the Run Status
screen.
To set up start, stop, pause conditions for air temperature sensors
1. Perform the steps in Searching For and Assigning Air Temperature Sensors on page 35.
2. Turn the dial to the Start, Stop, Pause position.
3. Press the Next or Previous button to highlight the Temperature Control Setup option.
4. Press the Enter button. The Temperature
Sensors screen displays.
5. In the Program column, press the + button to
highlight the program that you want to set up
the conditions for.
6. Press the Next button to move to the
Temperature Sensors column. Press the +
button to highlight the serial number of the
air temperature sensor that you want to set
up the conditions for.
7. Press the Next button to move to the Enable column of the Start field. Press the + button to
toggle the setting between the following values:
 Off – Tells the controller to ignore this condition
 Below – Start the program when the air temperature sensor detects a reading that is
below the setting in the Value column
 Above – Start the program when the air temperature sensor detects a reading that is
above the setting in the Value column
 Equals – Start the program when the air temperature sensor detects a reading that is
equal to the setting in the Value column
8. Press the Next button to move to the Value column of the Start field. Press the + button to
change the value in the field.
Page 61