Baseline Systems BaseStation 3200 V12 - Manual (Page 87)

BaseStation 3200 Advanced Irrigation Controller Manual
2. Press the Next button to highlight the Security Setup option, and then press the Enter button.
The Security screen displays.
3. In the Enable Security Levels field, press the + button to toggle between Enabled and
Disabled.
4. Press the Next button to highlight the first digit of the Admin PIN, and then press the + or –
button to change the number.
5. Press the Next button to move to the next digit, and then press the + or – button to change
the number. Repeat this step until you have configured all digits of the PIN.
6. Press the Next button to highlight the next PIN, and then repeat steps 4 and 5 until you have
configured all of the PINs.
Note: Be sure to remember which PIN is associated with which access level so you are certain
to give the correct PIN to the correct users.
7. When you have finished making changes, return the dial to the RUN position.
Setting the Two-Wire to Always On
In its default condition, the controller powers down the two-wire after 1 minute of idle time.
However, if you have a normally open master valve that is not connected to a separate power
source or you have a coach’s button that can be used at any time, you should set the two-wire to
be always on.
Additionally, if you are using a testing device to troubleshoot an issue with the two-wire, you
should set the two-wire to be always on.
1. Turn the dial to the Advanced position.
2. Press the Next button to highlight the Two-wire Settings option, and then press the Enter
button. The Two-wire Settings screen displays.
3. In the Two-wire Always On field, press the + or – button to toggle between YES and NO.
Changing the Serial Number of Your Controller
The System Settings option under the Advanced dial position allows you to change the serial
number of your controller. It also provides a set of system functions that you should only perform
under direction from Baseline Support.
WARNING! Only change the serial number of your controller when directed to do so by Baseline
Support. If you change the serial number, you will disable your ability to restore your system from a
previous backup.
Also be aware that it is easy to inadvertently change the serial number when you are in this screen.
We recommend that you avoid accessing this screen unless you are directed to do so by Baseline
Support.
Page 81