Baseline Systems BaseStation 3200 V12 - Manual (Page 81)

BaseStation 3200 Advanced Irrigation Controller Manual
Stopping an Active Program
1. Turn the dial to the Manual position.
2. Press the Next button to highlight the Start or
Stop Program(s) option.
3. Press the Enter button. The Prog Start/Stop
screen displays.
4. In the Program/Status column, press the +
button to highlight a watering program that
you want to stop.
5. Press the Next button to move to the
Start/Stop column. The field in this column
displays Stop.
6. Press the + button. The field in the Start/Stop column displays Start, and the program’s status
changes to Idle.
7. Turn the dial to the RUN position.
Manually Starting/Stopping the Zones of a Program
You can manually run one or more zones of a program for their programmed water times. You can
also use this option to stop one or more zones of a program that is currently running.
Example: After zones 1 – 3 of program 1 ran, you had to stop watering. Later, you manually start
program 1 again, and you can use this option to set zones 1 – 3 to done because they ran earlier.
1. Turn the dial to the Manual position.
2. Press the Next button to highlight the Start or Stop Program Zone(s) option.
3. Press the Enter button. The Zone Start/Stop
screen displays.
4. In the Prog column, press the + button to
highlight the program that has the zones that
you want to run.
5. Press the Next button to move to the
Zone/Status column.
6. Press the + button to highlight the zone that
you want to run.
7. Press the Next button to move to the
Start/Stop column. The field in this column displays Start.
8. Press the + button. The field in the Start/Stop column displays Stop, and the program’s status
changes to Watering.
Page 75