Baseline Systems BaseStation 3200 V12 - Manual (Page 85)

BaseStation 3200 Advanced Irrigation Controller Manual
4. In the Pump/MV column, press the + button to highlight the pump or master valve that you
want to run.
5. Press the Next button to move to the Run Time column, and then press the + or – button to
set the amount of time for the manual run.
6. If you want to add another pump or master valve to the manual run, press the Previous
button to return to the Pump/MV column, and then repeat steps 4 – 5 to set the time for the
next pump or master valve.
7. Press the Next button to move to the Concurrent Zones field. If you want more than one
pump or master valve to run at one time during the manual run, press the + button to change
the number in this field.
8. When you have finished making changes, turn
the dial to the RUN position. When the manual
run starts, the main screen shows the details.
9. If you want to stop the manual run while it is
active, press the Back button.
Note: When the manual run is complete, the
controller changes the Run Pump or MV for
Fixed Time settings to Off.
Setting the System to OFF
Turn the dial to the OFF position when you want to halt all watering for an indefinite period of
time. No watering cycles will be started. Use this dial position for seasonal shutdown. DO NOT
power down the BaseStation.
When set to OFF, the controller enforces the
following conditions:
• All current watering cycles will be stopped and
all zones will be set to Done.
• It will power down the two-wire (even if it has
been set to always be powered up).
Page 79