Baseline Systems BaseStation 3200 V12 - Manual (Page 98)

BaseStation 3200 Advanced Irrigation Controller Manual
10 – Reports, Messages, & Logs
The main screen shows basic information about the operating state of the BaseStation controller,
but additional reports and messages are available from the Reports dial position and the Messages
dial position. The controller provides the following categories of reports and each category can
have multiple reports.
• Zone Status
• Test All
• Moisture Sensor Data
• Water Times
• Water Used and Flow
• Operator Messages
Some reports, messages, and alerts are only available when specific conditions cause them to be
generated. For example, if the main screen indicates that a pause condition has occurred, you can
access the Pause message by turning the dial to the Messages position.
Zone Status
When the controller dial is in the RUN position, the main screen displays the Zone Status report.
When “BUSY” displays on the top line, the dial and buttons are locked out and will not work for a
time. The busy time can be several seconds, depending on the number of devices on the two-wire
and the number of calculations being done.
Page 92