Baseline Systems BaseStation 3200 V12 - Manual (Page 84)

BaseStation 3200 Advanced Irrigation Controller Manual
Manually Running Programs for a Fixed Time
1. Turn the dial to the Manual position.
2. Press the Next button to highlight the Run Program(s) for Fixed Time option.
3. Press the Enter button. The Run Prog Zones
screen displays.
4. In the Prog column, press the + button to
highlight the program that you want to run.
5. Press the Next button to move to the Zone
Time column, and then press the + or – button
to set the amount of time for the manual run.
6. If you want to add another program to the
manual run, press the Previous button to
return to the Prog column, and then repeat
steps 4 – 5 to set the time for the next zone.
7. Press the Next button to move to the Concurrent Zones column. If you want more than one
zone to run at one time during the manual run, press the + button to change the number in
this field.
8. When you have finished making changes, turn
the dial to the RUN position. When the manual
run starts, the main screen shows the details.
9. If you want to stop the manual run while it is
active, press the Back button.
Note: When the manual run is complete, the
controller changes the Run Program(s) for Fixed
Time settings to Off.
Manually Running a Pump or MV for a Fixed Time
If you want to get water to a hose bib that is attached to a master valve, you can use this option to
manually turn on the MV for a specified amount of
time. You can also use this option when you want to
test all your lines.
1. Turn the dial to the Manual position.
2. Press the Next button to highlight the Run
Pump or MV for Fixed Time option.
3. Press the Enter button. The Run Pump/MV
screen displays.
Page 78