Baseline Systems BaseStation 3200 V12 - Manual (Page 116)

BaseStation 3200 Advanced Irrigation Controller Manual
20.
21.
22.
23.
24.
25.
26.
Additional Information for Existing Programs
Program Watering Days Start Times
Programming Information for the BaseStation 3200 Controller
1. Use the table below to plan connections and programming before physically programming
the controller.
2. Determine which zone within each hydrozone will be the “primary” zone. If you are using a
biSensor, the primary zone is the zone where the sensor is located. You will set up the
watering strategy for the scheduling group based on the readings from that sensor. In the
BaseStation 3200 controller, you will designate this zone as the primary zone. Refer to After
you have configured the settings for the current zone, perform one of the following actions:
 To configure another zone, press the Enter button until the number of the zone that you
want to configure displays in the Zone field at the top of the screen. Repeat steps 3 – 9.
 When you have finished making changes, turn the dial to the RUN position.
Page 110