IDEC MicroSmart - Manual (Page 159)

5: S PECIAL F UNCTIONS
« FC4A M ICRO S MART U SER ’ S M ANUAL » 5-39
Displaying and Clearing Error Data
This section describes the procedure for displaying general error codes and for clearing the general error codes.
1. Select the Error menu.
2. General error codes are displayed. Clear the general error codes.
For details about general error codes, see page 29-3.
Starting and Stopping the PLC
This section describes the procedure for starting and stopping the PLC operation using the HMI module.
Note: The procedure described below turns on or off star t control special internal relay M8000 to star t or stop the PLC oper-
ation. When a stop input is designated, the PLC cannot be star ted or stopped by turning star t control special internal relay
M8000 on or off; the procedure described below does not work. See page 4-3.
1. Select the Run/Stop menu.
2. The PLC operation status is displayed.
3. Select RUN or STP to start or stop the PLC operation, respectively, using the ▲ or ▼ button.
OK
Go to control
screen.
OK
Clear the general error codes.
Return to the Error menu.
To abor t clearing the general error codes, press the ESC button
instead of the OK button; the Error menu is restored.
OK
Go to control
screen.
OK
Current Status
PLC operation status
RUN: Running
STP: Stopped
▲
Slow Flash
Switch to
STP or RUN.
OK
Slow Flash
Enable the
change.
ESC
Return to the
Run/Stop menu.
Changed Status