HP 700 - Manual (Page 25)

1-5
Company confidential. Murillo/Ravillo User’s Guide. Final Freeze Status: Frozen
This is the cyan on page 1-5 (seq: 23)
This is the black on page 1-5 (seq: 23)
Task 1: Check That You Have All the Items Required
1 You need the following items, which were supplied with the plotter.
Power cord
The power cord supplied with your plotter should meet the plug requirements for
your area. However, different power cords (international options) are available. If
necessary, contact your dealer or HP Sales and Support Office.
A roll of HP Opaque Bond Paper (for the HP DesignJet 700)
A roll of HP Coated Paper (for the HP DesignJet 750C Plus)
Print cartridge(s):
For the HP DesignJet 700:
– Two black
For the HP DesignJet 750C Plus:
– One yellow
– One cyan
– One magenta
– Two black
2 Inspect the plotter itself and the above accessories. If you received any item in a
damaged condition, notify the dealer or HP Sales and Support Office where you
purchased the plotter, and file a claim with the carrier.
3 You will also need the following items, which were not supplied with the plotter.
Interface cable
For details of suitable cables, see page 11-8.
4 If you have purchased extra memory, you will need your
Memory expansion module
For details of the memory expansion modules available, see page 11-14.
SETUP
1
Setting Up the Plotter
Task 1: Check That You Have All the Items Required
Supplied
700
750C Plus
Not supplied
Optional