HP 700 - Manual (Page 203)

11-7
Company confidential. Murillo/Ravillo User’s Guide. Final Freeze Status: Frozen
This is the cyan on page 11-7 (seq: 201)
This is the black on page 11-7 (seq: 201)
Interface Specifications
Below are the parallel and serial interface specifications.
Parallel (Bi-Tronics/Centronics)
Interface Pin Wire/Signal Name Source
Interface
The connector on the plotter is
1 Strobe computer
The connector on the plotter is
36-pin female.
2 ... 9 D0 ... D7 (data lines) both
p
Most existing parallel cables s pport
10 Ack plotter
Most existing parallel cables support
Bi-Tronics communication, but for
11 Busy plotter
use with this plotter, the cable must
meet the specification in this table
12 PError plotter
meet the specification in this table.
13 Select (SelectOut) plotter
14 AutoFd computer
16 GND
19 ... 30 GND
31 Init computer
32 Fault plotter
36 SelectIn computer
Serial (RS-232-C) Interface Pin Wire/Signal Name Source
The connector on the plotter is 25 pin
1 Protective Ground
The connector on the plotter is 25-pin
female.
2 Transmitted Data DTE
The plotter is configured as DTE (data
3 Received Data DCE
The lotter is configured as DTE (data
terminal equipment).
4 Request to Send DTE
q )
Data is transmitted on Pin 2 and
6 Data Set Ready DCE
Data is transmitted on Pin 2 and
received on Pin 3.
7 Signal Ground
20 Data Terminal Ready DTE
Reference
Interface Specifications
REFERENCE
11