HP 700 User Manual

Page 175

9-11

Company confidential. Murillo/Ravillo User’s Guide. Final Freeze Status: Frozen

This is the cyan on page 9-11 (seq: 173)

This is the black on page 9-11 (seq: 173)

If the Output Contains Only a Partial Plot

Did you press

Form Feed and Cut

before all the data was received by the

plotter? If so, you have ended the data transmission and will have to print the
plot again. (You normally don’t need to press

Form Feed and Cut

to unload

the plot.)

The

I/O Setup / I/O Timeout

setting may be too short. Increase the setting and

plot again. See page 7-9.

The file may be too big for the plotter’s memory. For information on memory
expansion modules, see page 11-14.

There may be a communications problem between your computer and the
plotter. Make sure interface cable is connected properly.

Check to make sure that your software settings are correct for your current plot
size (e.g., long-axis plots).

If you are using network software, make sure it has not timed out.

See also under “If the plot is clipped” on page 9-12.

This is the magenta on page 9-11 (seq: 173)

TROUBLE-

SHOOTING

Troubleshooting

Solving Problems with Plot Position or Content